The last step in finishing was to add pockets. I played around with different sizes and debated two versus four. A great way to visualize size and placement is to cut pockets from shop towels (they are heavier than paper towels) and play around until you get the right look.
I had four larger buttons and decided to add them at the center front. They are sewn at the right front edge and don’t actually fasten.
I find it easiest to get pockets exactly the same size and shape by pressing the pocket around a cardboard template. I interfaced the pocket with bias cut interfacing which is cut just a tad smaller than the finished pocket. The bias gives the pocket a softer shape. I cut a slightly smaller template for the lining.
Slip stitch the lining to the pocket, attach trim and slip stitch to the jacket. Don’t catch the lining when doing this.
I had a chance to get a closeup look at some geniune Chanel jackets at an upscale resale shop on Madison Ave. and noted some distinctive details. Trims are applied after construction and are made to be removed if necessary for cleaning. More about my findings in the next post.
I was sidetracked by an request from my daughter-in-law. She was invited to join the hunt staff of our local equestrian team. Hunt staff wear red jackets and bespoke versions are a small fortune. Since I had made her wedding gown, she figured a jacket would be an easy task.
Just make a tailored jacket from a commercial pattern, right? Wrong. Riding clothing is another animal. We combined my research and her knowledge and came up with a punch list of what this garment needed.
*Roomy armholes with significant ease in the back to allow the rider forward arm movement
*Sleeves pitched much more forward than conventional clothing as the arm is held almost horizontal
*Abrasion resistant lining in the jacket skirt to resist wear
*Flared skirt with most of the flare at the back to cover the seat while in the saddle
*Warm lining as hunt season runs through the winter
*Slippery sleeve lining to allow the jacket arms to slide freely over shirts/sweaters
Mood Fabrics had a beautiful heavy wool/cashmere/nylon fabric. They also had abrasion resistant lining and wool flannel for the upper jacket lining. I drafted a fitting muslin from cotton canvas which mimicked the weight and drape of the wool better than lightweight muslin. Note the exaggerated curve of the sleeve.
The roomy armhole. I would never have guessed this much ease would be required.
The jacket fabric was thick and required loads of steam and heavy use of a tailors clapper to get things flattened into shape. I found it helpful to flatten the inside of especially bulky seams with a clamp from the hardware store. Get loads of steam into the fabric, clamp it down hard, and leave until it’s cold.
Also, don’t sew across the layers of intersecting seams. You can get a much flatter press by folding the seam allowances to one side and end the stitching at the seamline. Fold the seam allowances the other direction and begin stitching at the seamline. The seam allowances will remain free and press much flatter.
Inside the jacket showing the various linings used.
The color of the upper collar is unique to the particular hunt club; her’s is purple. The fabrics were so heavy and it was applied with traditional tailoring techniques.
Here’s the finished work.
I couldn’t resist using the leftover fabric for a matching jacket for the one year old. Fittings were a bit of a challenge on a squirmy baby but we got it done!
Mommy and daughter out for a ride.
