Monthly Archives: September 2016

Chanel Shoulder Pads

Anyone who has constructed their version of the classic Chanel quilted jacket is aware that there is no provision in the design for shoulder padding. Unfortunately, many figure types are enhanced by the addition of even just a slight lift at the shoulder line. I came across this RTW Chanel quilted jacket WITH shoulder pads.

jacket1jacket2

The lining is silk chiffon and is difficult to see in the photo. Each section of the jacket, including sleeves, is quilted in vertical lines about one and 1/4 inch apart. The lining seams are finished by hand: amazing to find this in RTW! There are also shoulder pads covered with the silk chiffon. Happily I was able to get inside this garment and copy the details.

jacket3

Here is the jacket wrong side out with the shoulder pad visible and the pattern I was able to reconstruct. The inner working of the shoulder pad were identical to a pattern I previously posted on 1/20/2016: The Chanel Shoulder.

Here is a copy of the shoulder pad itself:

shoulder-pad-pattern

I don’t have pdf conversion software, but if you right click anywhere on the pattern you will have an option to print. Print to fit on 8.5 by 11 paper and it should print to the correct scale.

I’ll run through the construction of the shoulder pad again so readers don’t need to toggle back and forth between posts.
pieces1pieces2
On the right are the sections cut from cotton batting. Left photo shows the sections completed. Check the post from 1/20 if you need additional hints.

12

I’ve shown the inner layer (pattern piece 3) placed on the mannequin first, topped with the optional additional padding (pattern piece 4). Stitch these layers together.

34

Pattern pieces 1 and 2 (already stitched together) are layered on top and pinned for sewing. Next photo shows the completed shoulder pad.

5

Since the lining in this jacket has already been attached by quilting, the shoulder pad needs to be covered by matching lining. Here are the lining pieces: Shoulder Pad Cover

 

67

Sew the darts in both top and bottom cover pieces. Notice both sections are cut out bias grain. There is also NO SEAM ALLOWANCES on the outer edges. Allow about 3/4 inch or 2 cm. Pin the upper cover (the piece with two darts) on the top of the pad. Stitch just INSIDE the edge of the batting.

89

10

Place the bottom cover section on top of the top cover layer and stitch just OUTSIDE the batting. I find it easier to sew with the cotton batting layer on top and the silk fabric next to the sewing machine feed dogs. It controls the ease better.

1213

Leave about 2 to 2.5 inches open along one side to turn. Trim the seam allowance to 1/8 inch. I increase to 1/4 inch around the opening the make sewing that closed easier.

cons14cons15

Attach to the jacket with 1/4 inch French tacks so the shoulder pad will move slightly when worn. I usually use four tacks: one at each end of the shoulder seam and one at front and back where the sleeve joins the jacket body. These aren’t limited to Chanel jackets. Anytime you need a covered shoulder pad these are wonderful. I like that the sleeve head support is incorporated into the design. Also the pad is securely stitched to the lining so these should withstand the cleaning process. Enjoy!

 

 

 

21 Comments

Filed under French Jackets