For the backyard wedding, I wanted something easy, yet elegant. When you’re the resident dress designer/maker, showing up in something not of your own creation doesn’t work! I had my hands full with the bride, mother of bride, bridesmaids, etc. but managed to crank out a tunic style dress with Coco (and Karl) in mind.
My starting point was fabric from the Haute Couture section of Mendel Goldberg Fabrics. I chose a wonderful French boucle highlighted with tiny sequins woven into the fabric. With careful planning, the dress required only one yard of fabric; here is what was left over.
I used my basic pattern block and made the following adjustments. If you start with another tunic style pattern, and want to get this look, make sure your pattern has a high, jewel neckline. If your pattern has a lower neckline, the collar might be too large and will stand away from the neck.
Close the armhole and shoulder darts, combining them into the underarm dart. Angle the new underarm dart towards the lower edge.
I chose to eliminate the front fisheye darts and transfer some of the dart shaping to the side seam. The bib placket drops from just outside the neck edge to the bust line. I played with shaping the bib wider at the top and tapering slightly but that design created a problem with trim placement. Having the bib placket the same width from top to bottom allowed the trim rows to be evenly spaced. The back was used as is with fisheye darts. The shoulder dart will be eased. The skirt was pegged about 3/4 inch from low hip line to hem.
Next I drafted a collar and stand. Some drafting books suggest curving the collar stand about 1/2 inch but I find the stand will hug the back neck better if more shaping is used. I’ll increase the curvature of the stand by shaping with a steam iron.
All collar pieced are cut from cardboard which will help when pressing. I’ve also cut a collar lining pattern 1/8 inch smaller to keep the undercollar out of sight. The Curve Runner makes measuring curved edges easy; very helpful when drafting collars to fit the neck.
The cardboard helps when pressing seam allowances under and ensures the collar is perfectly symmetrical. Fell stitch the under collar to upper collar.
Pressing over cardboard also helps shape the collar stand. I used satin faced organza to line the collar, stand and as a base fabric for the bib. This organza is more opaque and stiffer than regular silk organza and is harder to shape into a smooth curve.
Designing trims for the placket was the most fun part. I used the same satin faced organza as a base fabric and applied multiple layers of ribbons and braids. Most were sewn on by hand to maintain a soft, couture feel.
I had some leftover tweed from Linton. I save my scraps of tweeds and boucles as there is often wonderful trim hiding in the fabric. Linton fabrics are woven with continuous strands so un-weaving produces a long continuous length of trim. I also used the fringed selvedges from the French boucle. Also found great buttons!!!
I had just enough scraps to cut bias strips for a hem fringe. Two layers of cotton batting padded the center. A blunt tapestry needle helps to un-weave the edges.
Finished! Here’s a glimpse of the inside. Silk crepe de chine fell stitched to armseyes and placket. Side zip makes it easy to get into.
Next post will detail the design and construction of the bride’s outfit.
